#11
|
|||
|
|||
Nice work so far, very excited to see how this develops. Happy building, and thank you for sharing.
|
#12
|
||||
|
||||
Hello Ragnar ,
thank you , and enjoy it Next component, the pilot seat consists of 32 parts, first the seat shell is built. The "Fotelu Pilota" will be finished with the other small pieces. In order not to damage the pilot seat in the further course, he is still fixed. Kind regards Kurt |
#13
|
||||
|
||||
Hello !
After three days of mountaineering in the Julian Alps, it is now here .... The target is again mini model building. The fittings consist of three parts. Paint the punched holes with toothpicks ... ... stick to foil ... ... and put the whole into the cockpit. Thus, the cockpit is ready. Best regards Kurt |
#14
|
|||
|
|||
Fine cockpit, Kurt
It looks quite cramped! |
#15
|
|||
|
|||
Clean work! Looks great.
|
Google Adsense |
#16
|
||||
|
||||
Hello
and it goes on ... Parts 42/43, the cockpit interior trim. I'll start with the back sides. Glue the front part to one side and then close. Best regards Kurt |
#17
|
|||
|
|||
Fantastic build so far!
|
#18
|
||||
|
||||
Hello everybody ,
The white areas are trimmed for the trunk part A6. I'm still not quite clear how it goes here, there is a gap of about 2 cm? Since the trunk part A5 even after some grinding does not fit on the frame B11 I must share this, nevertheless, there is an opening about 2 mm wide which is closed with "Rezerva Koloru". The four parts for the fuselage tip fit together better. Thus the hull tip is finished, but with some difficulties. regards Kurt |
#19
|
||||
|
||||
Hello !
Now there is the first big problem, the frame B 6 is 3 mm too wide!? After a radical correction of the fi ... ... the part fits then but still one. Fuselage parts A8 and A9 with ... ... fits well together . The frame of part A10 is open on the inside. Best regards Kurt |
#20
|
|||
|
|||
Hey Kurt
I think that for simple models such as the Mirage, there is no need for a chassis method with disks/formers, that should then be wrapped in paper, it just complicates construction.....And I'm talking about the front section of the model. In my humble opinion, in such simple models, the method of sectional parts with formers one by one is the easiest and most comfortable. Good luck later, and I'm sure you can finish the model as needed, despite all the difficulties and inaccuracies of the model. YOAV |
Google Adsense |
|
|