#21
|
||||
|
||||
Hello YOAF ,
I have to give you a ruling on the sections on the fuselage Hello everybody Now glue air inlets, part 20 + 21. Caution !! Do not reinforce! Allow the frame to dry thoroughly and glue part A24 with the printed side inwards. The parts for the lining and cannon. regards Kurt |
#22
|
||||
|
||||
Hello !
Cannon built and panel well rounded before. On the inside the strips A27 to A30 are fixed. The panel A 26 should be glued to the outside, and this part is still a bit complicated. The air inlets fit well to the hull even without gluing. Best regards Kurt |
#23
|
|||
|
|||
good work or the air intake.
funny thing that I've noticed now.... some of the Hebrew script on the side of the air intake is reversed ... Both the letters are reversed and the order of the words is reversed. The model designer had to have a little more effort on the subject of writing. YOAV |
#24
|
||||
|
||||
Oops , the stencils are indeed inverted
They did not pay attention Isaac
__________________
My gallery [http://www.papermodelers.com/gallery...v-r-6&cat=500] Recent buildsMeteor F1, Meteor F8, Mig-Ye8, NA Sabre, A-4E Skyhawk,Mig-15 red, Mig-17 repaint |
#25
|
||||
|
||||
Hello Isaac & YOAV ,
because of my nonexistent Hebrew knowledge, I have not noticed this, of course, but it is an interesting detail. The frame parts are glued to the pulpit ... ... and immediately the first fitting, not yet glued. Best regards Kurt |
Google Adsense |
#26
|
||||
|
||||
Fine work on the cockpit framing.
Don |
#27
|
||||
|
||||
Thank you Don ,
Hello everybody , Before assembling the body parts, toothpicks are glued inside ... ... whereupon the cockpit part is glued first. The left air intake fits relatively well. I have coped quite well with the new construction method. Parts A14 + A15 are glued to the hull behind the cockpit. Best regards from Styria Kurt |
#28
|
|||
|
|||
Good idea, using toothpicks as alignment studs. Looks to have worked quite well.
__________________
This is a great hobby for the retiree - interesting, time-consuming, rewarding - and about as inexpensive a hobby as you can find. Shamelessly stolen from a post by rockpaperscissor |
#29
|
||||
|
||||
Hello !
and further ... The parts for the tail fin are prepared. First, the container for the brake parachute is glued on. Now adjust the frame on one side ... ... close and install rudder. Glue the tail fin with the front tip of the fuselage. Best regards Kurt |
#30
|
|||
|
|||
Nice work on the stabilizer.
YOAV |
Google Adsense |
|
|