MiG-29, 1:24, foam former Design - Page 2

**Mike1158** · #11 08-24-2018, 10:16 AM

This is a fascinating project, wondering if there is an alternative, even a self adhesive material that could be printed and 'stuck' on the depron to allow the graphics to be retained.

**Pepo** · #12 08-29-2018, 12:51 AM

Small update again!

**Pepo** · #13 08-29-2018, 12:59 AM

And pictures here. Uploaded from mobile phone

In place of the elevators need some balsa or plywood reinforcement!

**Rata** · #14 08-29-2018, 04:48 AM

Fascinating build Pepo. If you do decide it will be a flier, you're a much braver man than me- putting all that time into a model and then giving it a heave-ho into the blue!

**Pepo** · #15 09-05-2018, 03:08 AM

Very light update. The foam capability for forming is surprising! The inlet for APU is made from 0.5 mm thick Vector foam.

**Pepo** · #16 09-13-2018, 09:26 AM

Vertical fins!

**Pepo** · #17 09-19-2018, 05:09 AM

Engine nacelles and I have to say that this origin card model plane is geniously designed. Everything fits very well also when i using this 1mm thick foam.