#21
|
||||
|
||||
Hello Stipa fans
small but nice construction steps ... Behind the front seat, the pedals and fittings are mounted ... now install the rear pilot seat Yours sincerely Kurt |
#22
|
||||
|
||||
Now the interior lining, where a frame is glued ... you do not see much of it, but I did it
Glue parts 27 + 28 ... to the inner wall Yours sincerely Kurt |
#23
|
|||
|
|||
The inner and outer fuselage skins seem to fit perfectly on the complex struture
The safety chains are not a common feature, right? Well, this is not exactly an orthodox plane... |
#24
|
||||
|
||||
Weird aircraft indeed!
I assume the safety chains (if that's what they are) are instead of seat belts, and the straps on the seat are for the parachute (?) at the back? Do not fancy the safety chains - they imply you would turn into mince! ------------ An hour in the evenings Kurt? You are a faster builder then I am...
__________________
The SD40 is 55 now! |
#25
|
||||
|
||||
Hi Kevin ,
yes, I think that the straps are the parachute Building the inner wall ... On the left side there is the option to open the entrance hatch ... ... the hatch is cut open and later replaced by the extra built ... now it's exciting, it follows the paneling of the cockpit Yours sincerely Kurt |
Google Adsense |
#26
|
||||
|
||||
Following with interest Kurt.
__________________
''Oh, stop whining! Can't you just print off another one?''- my wife ca 2018 |
#27
|
||||
|
||||
welcome Rata
Hello , I start with the part at the flap opening ... and keep on going With Part 29 it will be exciting again ... because my balls are used Yours sincerely Kurt |
#28
|
||||
|
||||
What is the ball tool used for? Helping to get the flat part rounded?
The cockpit section looks great! Cheers, Chris
__________________
website: http://www.papierschnitzel.com - patreon: https://www.patreon.com/papierschnitzel - facebook: https://www.facebook.com/papierschnitzel |
#29
|
||||
|
||||
Hi Chris ,
thank you , yes I use the ball tool to round such parts . now letīs go on First apply a piece of Spant 9 ... then fit small pieces of a layer of toilet paper with glue. As a base, I use a glass plate, so I can press without the bottom sticks to the ground. When growing the first inaccuracies arise, it lacks 2 mm Yours sincerely Kurt |
#30
|
||||
|
||||
Looking nice.
If you can at this stage - just a suggestion - maybe look at replacing that chain with a little bit of real chain? Unless you want it all paper!
__________________
The SD40 is 55 now! |
Google Adsense |
Thread Tools | |
Display Modes | |
|
|