|
|
|
#41
07-20-2019, 10:53 AM
|
||||
|
||||
|
Nice clean assembly, Sergio. Did you spray a clear coat on the card stock? It has a nice shine to it.
Gary
__________________
"Fast is fine, but accuracy is everything" - Wyatt Earp Design Group Alpha https://ecardmodels.com/vendors/design-group-alpha 
|
|
#43
07-20-2019, 02:53 PM
|
||||
|
||||
|
Thank you very much!
Gary, always sprayed with lacquer for hair leaves, protects the impression during handling. But in this model I am finished and this original. I do not have a printer and I go to a copying center, they are laser prints and come with certain brightness, and they are very sharp. Gene k, luck that I could correct the disaster I did, otherwise I would remain at war with myself!
|
|
#44
07-20-2019, 02:56 PM
|
||||
|
||||
|
Looking forward to seeing the next photos.
Super work Sergio.
__________________
So long... and thanks for all the fish.
|
|
#45
07-21-2019, 11:01 AM
|
||||
|
||||
|
Thanks Steve!
Today the front wheels, wire and welding is what gives me the best result. It is a very entertaining job.Then you have to paint this. The templates that Krzychu74 provides gives us the right measurements. The result what I achieved is very good.
|
| Google Adsense |
|
#46
07-21-2019, 11:13 AM
|
||||
|
||||
|
I enjoy your construction and the way you present it .....
|
|
#47
07-21-2019, 11:54 AM
|
||||
|
||||
|
That is extremely intricate. Nice work, Seregio.
Gary
__________________
"Fast is fine, but accuracy is everything" - Wyatt Earp Design Group Alpha https://ecardmodels.com/vendors/design-group-alpha
|
|
#48
07-21-2019, 03:27 PM
|
||||
|
||||
|
Great soldering! Really neat and tidy work.
Thanks for sharing your step-by-step pictures. I've got to do some soldering for the railings on my U-boat and I'm not looking forward to it...
__________________
So long... and thanks for all the fish.
|
|
#49
07-22-2019, 08:38 AM
|
||||
|
||||
|
Asaf, Gary, Steve, thank you very much.
Small progress but advance to the end. The tail skate, the most delicate thing was to close the thin supports with the thin wire inside, but it closed very well and it was stronger. Place the vertical stabilizer, be held only by a notch that fits the shaft has to be a firm union, probe with CA but detached. Suddenly a drop of PVA achieved the firmness that needed. There are few parts, machine gun, propeller and some details. And then the wired, which I do not think is simple. Thank you very much.
|
 |
|
|
Linear Mode
