Help with the Alan Rose DC3

[Greelt]

Hello all,
When cleaning up my computers hard disk, i came across the Alan Ros DC3 which i downloaded years ago.
I decided to build this beauty. When printing i ran into problems with page 35 of the manual and
pages 21 and 22 of the parts. All of those pages contain an image of the engine and i am not able to print them.
Does anyone else had the same problem or is it just me.


Thank you for your response.


Greelt

[Bengt F]

Hi Greelt!
I might be able to help you out...

I think I have saved ALL the files, and I just looked up the "Instructions Book" (digitally restored by Rubén Andrés Martínes Arias in 2012) with the cover of Peter A. Zorn. Page 35, with the motor assembly, looks OK.

And the parts pages 22 and 23 of the model (DC-3 in CF-CPY livery, Yukon's Wind Vane) looks OK, too. Page 22 contains an engine with nacelle, and page 23 all the props and the two main landing gear (front), it seems.

Would it help if I send you the two PDF files as a Message?

All the best, Bengt in Stockholm

[Rubenandres77]

Sorry for the late response.
Thanks Bengt for checking and reporting!


I also checked and can confirm the master PDFs are OK.

I can suggest to open the PDF files with Foxit reader instead of Acrobat. Foxit always shoes the graphics fine.
Seems like some versions of Adobe Acrobat don't render correctly some fills and therefore the page appears cut, empty, or some colors don't show (even though the graphics are there).


Regards.

[Greelt]

Thank you gentlemen for your quick response.
Foxit Reader did the trick, happy to start building now.




Greelt

[Kevin WS]

Enjoy, and post a build thread!