|
|
|
#11
10-24-2009, 12:54 PM
|
||||
|
||||
|
I was wondering about that! They look to be easier to sharpen than an Xacto or Excel blade as they're not angled as sharply. I might give them a go on my dremel or even stropping them on an old belt. Good call Lehcyfer
__________________
http://burnedofferings.com/shop 
|
|
#12
11-01-2009, 06:06 PM
|
||||
|
||||
|
I still like scalpel blades the best
Chris
__________________
Want to buy some models from independent designers? http://www.ecardmodels.com and visit the shop!
|
|
#13
11-02-2009, 12:57 AM
|
||||
|
||||
|
Ron0909 - I use a sheet of high grade sandpaper - intermittently one and the other side, then check if I can see the edge when orientated vertically - if I see a bright line or spots of brightness it's not sharp yet - when I can't see the line of the blade it is sharp.
I use Dremel only in case when the blade point has broken off. Then I grind the blade from the blunt side until it is sharp again. Sometimes I grind a fresh blade - to get a very sharp point. I've shown it here - in Polish, but the pictures explain it all
__________________
- Do not try to make a model. Instead only try to realize the truth. - What truth? - There is no model. Then you will see that it's not the model that you make, it is only yourself.
|
|
#14
11-05-2009, 01:00 PM
|
||||
|
||||
|
Any updates Ron? Been wanting to see your progress.
|
 |
|
|
Linear Mode
