#21
|
|||
|
|||
One small issue but it might be my own fault (card used to laminate frames a bit to thisk..)
This little part circled in red came out shifted about 1mm from where it supposed to be when I dryfitted the skin. Simplest solution was to cut it out and glue in correct place over the frame. Tomorrow I'm planning to finish and mount the wings.
__________________
Constructive criticism of my builds is welcome - if I messed up and allowed others to see it, I certainly deserve it Michael Krol |
#22
|
||||
|
||||
It looks great, Mike.
|
#23
|
||||
|
||||
Mike,
This is looking good. It will need to go in my collection. ---- Yes folks I do exist. :D Still unpacking after three months.
__________________
DWG (AKA Dave G) Elgin, IL (USA) {{ RPM - Redneck Paper Modeler }} |
#24
|
||||
|
||||
Had enough of the snow yet, Dave? Welcome back to Fantasy Island.
__________________
Ashrunner "If you don't know what a lahar is, don't get in its way!" My Designs -- My Photography |
#25
|
|||
|
|||
Finished and mounted the wings so the time came to install wing fillets.
This proved a bit tricky to get it right but I think result is pretty good Here I decided to vary from the numerical sequence since it seemed to be more natural and easier to do it as follows: 1. Glue in place part 65 2. Form and glue part 66b 3. Form and glue part 66a 4. Part 64 will be installed after I finish fillets on the other side of the plane Second photo shows general view of the plane at this stage - just coudln't resist to show off :D
__________________
Constructive criticism of my builds is welcome - if I messed up and allowed others to see it, I certainly deserve it Michael Krol |
Google Adsense |
#26
|
||||
|
||||
Looking better and better Mike -- and keep up the pace! I'd like one for the to-be-built collection...
__________________
Bill Geoghegan Easton, Maryland USA www.geoghegan.us Current build: GPM Halberstadt DII |
#27
|
|||
|
|||
Glad to see you responded to my (private) motivational methods....LOL. Looking great!
|
#28
|
||||
|
||||
Awesome, Mike!
__________________
Chris Currently have way too many hobbies |
#29
|
||||
|
||||
Great job on the fillets! Coming together nicely.
__________________
-Dan |
#30
|
||||
|
||||
Great looking filletts, excellant build Mike!
|
Google Adsense |
|
|