#1
|
||||
|
||||
Yamaha MT-10
Hey All
I have decided to build the Yamaha MT-10 for two reasons. 1: I am using 80 gram paper this time to build the model as against the 160 gram that I have normally used in the past and I have had issues in the building of the V-MAX and R1M in that part just seem to be a bit on the over sized scale and model does not fit together as I would want it to. 2: If this works I am going to re-build the R1M again as from failed first go with the same formula in point one. I have printed all the pages out from a colour laser printer, I have done all the marking of the bend lines and I have found that none of the ink has lifted from the paper yet, when I bent the Train model from Canon I saw that there was some ink lifting from the paper when I did the marking of the bend lines of which later resulted in ink coming adrift from the paper. But figures crossed lets see how this build goes. Retunga |
Google Adsense |
#2
|
|||
|
|||
Glad to see you getting back on that horse. The MT-10 looks as if it will be a real beauty once finished.
__________________
This is a great hobby for the retiree - interesting, time-consuming, rewarding - and about as inexpensive a hobby as you can find. Shamelessly stolen from a post by rockpaperscissor |
#3
|
||||
|
||||
Well I am going to start tonight or tomorrow tonight, seen how the house and family decide to not bug me
|
#4
|
||||
|
||||
Well I have finally started the model build, I have finished the first part of the front cowl.
R |
#5
|
|||
|
|||
Hi Retunga
A clienic tip if you cut away the glue strips of the model and at the bottom new start the sides become much sharper and you get no height difference. Example A: glue stripped away. B: the whole piece is reinforced from underneath and cut out, lines with an empty pen crossed so you get a nice folding seam. C: Without reinforcement D: With reinforcement.
__________________
the paper wizard is a purist |
Google Adsense |
#6
|
||||
|
||||
Amazing. It looks so detailed that if you put gas in it, it will run
Good luck with the build, I want to see that bad boy finished.
__________________
You forget a thousand things everyday, make sure this is not one of them. Current build:R33 Nissan |
#7
|
||||
|
||||
HI All
Some photos of the first part of the bike that I have now completed. Next part to do is the side covers. R |
Thread Tools | |
Display Modes | |
|
|