Lambo Murcielago

**2Kamser** · #1 07-05-2009, 02:34 PM

hi fellow modelers
i started a thread at z on my 1:14 scale build of the Lambo Murcielago from http://papercars.wz.cz/download.html
i've come so far as i have built the front and are now in the process of assembling the cockpit (at least that is what it looks like at 200Mph+ speed

)
but i've run into problems, if anybody has built that one, please tell me how to assemble the dashboard.
i did a build of it that ended up skew so i had to start all over again, but the prospect is that it will skew as well
do i miss something from the drawing (which is not too clear)
took me a good while to figure out where parts 55L+R were supposed to go

**Nazgul** · #2 07-06-2009, 02:04 AM

I built this one a coupla months back. However, I found the model to be quite straightforward, even at 1:18. Which part number are you stuck on? I'm not promising anything but I'll try to remember.

**ct ertz** · #3 07-06-2009, 10:57 AM

Sorry, I can not offer any help on this model but I thank you for the download link!

**2Kamser** · #4 07-11-2009, 12:39 PM

Hi Viraj
it is parts 55L+R, the ones on the right side of the console and connects somehow to the dashboard.
when i glue on the doorsides, the driver's side is ok but the passenger's side ends up skew
i rebuilt the cockpit but have halted here as i can't make heads or tails on it
best wishes
/Håkan

**Nazgul** · #5 07-30-2009, 08:41 PM

Sorry about the late reply, but here goes. 55 L & R are the two sides of a flat piece. Just glue them together so it makes a flat piece with both sides showing printed paper. It goes adjoining the center console and the dash. the curved edge should fit in to the curve of the dash. this should go on the passenger side of the interior. If you look at the instructions, it's pretty obvious. (I suppose the instructions for both the 1:14 and 1:18 are the same, I'm looking at the 1:18) I hope this helps.

**2Kamser** · #6 07-30-2009, 11:58 PM

hi Viraj
thanks for the tip, pretty much abandoned it for the time being
but will get back to it soon again and see if i can't get it done
/Håkan

**Nazgul** · #7 07-31-2009, 03:43 AM

I hope you will come around to it. It's a beautiful model when finished. I have done a few cars so far so trust me when I say it's not too difficult to figure out.

**2Kamser** · #8 09-12-2009, 03:46 AM

well i'm back at it again, assembling the cockpit for the second time
hopefully i have enough experience and tools not to screw it up again