#31
|
||||
|
||||
Good grief Kurt.
It looks wonderful, but so much work!
__________________
The SD40 is 55 now! |
#32
|
||||
|
||||
Hi Kevin ,
it is not so much , only three days The finished "wheel pile" ... ... is installed in the back ... and in front With best regards Kurt |
#33
|
||||
|
||||
The holder for the spare tire I do not make as intended from wire, but from 0.7 mm cardboard ... I like that better ...
... you will not see much of it after completion anyway With best regards Kurt |
#34
|
||||
|
||||
Now reinforce the subfloor with 1 mm cardboard and glue the floor to the load compartment On the inner wall of the cargo space, the frames for the windows are installed ... which fit very well With best regards Kurt |
#35
|
||||
|
||||
The parts for the lattice frame of the box body are not installed at the moment ...
... because before I glue the frame parts ... ... on the underbody ... and the first fitting - fits !! With best regards Kurt |
Google Adsense |
#36
|
||||
|
||||
Now glue the frame parts ... to the inside wall, color the edges black (rubber seal)
Now it's exciting, first I glue the right inner wall with a carrier, the left inner wall is also prepared with a carrier, let it dry well With best regards Kurt |
#37
|
||||
|
||||
To connect the floor to the side wall, I make tabs of 0.3 mm cardboard
Successively "weld" the ridge turrets with thick glue ... then install four ridge turrets in between With best regards Kurt |
#38
|
||||
|
||||
The sky good preliminaries ... and dry fit, genuinely ingenious, sits perfectly even without glue! First, I glue the roof riders over the entire length ... then I weld the roof riders and the side edges with thick glue, everything only from the outside! Of course, the first fitting with the chassis With best regards |
#39
|
||||
|
||||
It follows cab floor and underbody with wheel arches ... first glue the side panels ... ... then cover With best regards Kurt |
#40
|
||||
|
||||
I strengthen the back wall 84 with 3 mm Finn cardboard ... and glue it to the wheel arches Parts 81 + 82, the "motor hump" ... close the slots with small tabs and glue the frame a bit ... ... glue the second frame under the crease ... and place it all in the cab With best regards Kurt |
Google Adsense |
|
|