#1
|
|||
|
|||
Aston Martin DBR 9
Hello Model builders.
Currently I'm fooling around with the Aston martin DBR-9 Now I'm stuck at some parts not sure where it fits in maybe one already build this paper model. The part numbers is G44 & G45 Thanks Regards Henry |
Google Adsense |
#2
|
||||
|
||||
Henry,
Parts G44 & 45 make up the lower front opening of the bumper. See instructions, pg 2, #10, (attached). J |
#3
|
|||
|
|||
Hi there. Nice to see somebody else building this car.
I had the same problem with those parts. I have a buildlogg here Aston Martin DBR-9 LeMans 2005 I look thru my buildphotos and ill be back to you |
#4
|
|||
|
|||
Aston Martin
Thanks Will - I've got it !!
Not sure how I missed it!! |
#5
|
|||
|
|||
Ok
Would love some pictures when your build is finished /Wilhelm |
Google Adsense |
#6
|
|||
|
|||
Thanks Wilhelm.
Just depend if it's going worthwhile at the end, otherwise I will start from scratch |
#7
|
|||
|
|||
Parts 42 - 45
Hi hrogers
Here are my buildphotos of the parts. First part 42-43, these part have to be glued on the upper part of the bumper. Picture 3 and 4 shows the position of the part 42-43 and part 44-45. I turned the front-piece upside-down, so I could take the pictures. So part 42-43 in the upper-part and part 44-45 in the lower-part of the bumper. The part 44-45 I decided to make round, but that is my interpretation of those two pieces. Hopefully this helps you in your build. /Wilhelm |
#8
|
|||
|
|||
Aston Martin
I'm done with the project with a a lot of errors.
Hopefully next one will be better. I did not add the roller cage. Minor parts was not attached here is the end result |
#9
|
|||
|
|||
Lovely car...
Nice work, hrogers. You did a great work with a difficult model. I like the outcome very much.
/Wilhelm |
|
|