This being my very first post of a project I made is a bit daunting. So here goes! I am building this to add to my O scale train set. The model can be found on the Disney Experience site.
The Disney Experience
The Temple is quite a project with 491 pieces. The finished width is 13 inches, height 21 inches and the depth is 16 inches.That being said, it is a little too large for my train layout. At first, I tried several printer settings to get it down to fit into my available real estate. I wound up printing two pages per sheet and went to work. That gave me something about 13 inches high and about 8 inches on the sides. (And saved on paper!)
The directions are very important on this build. I often built a part then had an "ah ha" moment and printed out the part again. Mine is made of 65 lb. card. I have a few more in progress photos for the next post.
Thanks-
06-11-2018, 03:05 PM
Threaded Mode