|
|
|
#11
06-20-2014, 09:16 AM
|
||||
|
||||
|
Dear VK:
I give up did you print this one on 8 1/2 in. by 11 in. paper to give a 3 in figure or did you print it on 11 in. by 17 in. paper to give a 6 in. figure. The first figure of Zios I did 6 in. the one I am doing now I copied onto 54 # watercolor paper and it will be 3 in., In the future I shall go back to bigger is better. Arthrites fingers, Miles 
|
|
#12
06-20-2014, 09:37 AM
|
||||
|
||||
|
I printed this one straight on 8 1/2 X 11. From bottom of base to top of head he is 3 15/16 inches tall. Would be a little taller than some of the 3 3/4 inch action figures out there. The only issue at this scale is all the detail work on the helmet.
As I have never done well with petals (top of head and the shoulder tops), I started with the head. The helmet was almost scary at this scale (and yes, I did sneeze while building and the little lion on the detail work went into hiding. I did eventually find it again). This was my first Zio figure, so I figured I would start with what I knew would give me the most trouble. I didn't want to be 90% done and have to chuck it in the bin. If I remember correctly the helmet detail work was 9 pieces.
__________________
A fine is a tax when you do wrong. A tax is a fine when you do well.
|
 |
|
|
Linear Mode
