2019 All NEW Ecardmodels release thread

[3Turner]

Four kits from Brent's Repaints listed tonight



Bf-19K-4
https://www.ecardmodels.com/product/...3-paper-model/

CA-27 USS Chester
https://www.ecardmodels.com/product/...r-paper-model/

F-4 El Toro Bravo
https://www.ecardmodels.com/product/...o-paper-model/

F-4 SCAT XXVII (Robin Olds)
https://www.ecardmodels.com/product/...i-paper-model/

[3Turner]

And next are 4 kits from Scissors and Planes



9kit bundle of DH Vampire
https://www.ecardmodels.com/product/...5-paper-model/

8kit bundle of Early version of A-4 Skyhawk
https://www.ecardmodels.com/product/...e-paper-model/

7kit bundle of the FW-190D
https://www.ecardmodels.com/product/...e-paper-model/

7kit bundle of the TA-4 Skyhawk two seaters
https://www.ecardmodels.com/product/...e-paper-model/

[3Turner]

A couple models listed tonight from Short Studio, one was previously available on Ecardmodels old store software.



B-25 Mitchell Doolittle Raider (reissued)
https://www.ecardmodels.com/product/...y-paper-model/


Douglas TBD Devastator
https://www.ecardmodels.com/product/...8-paper-model/

[scon10]

Tai, may I pass on some suggestions to improve your great model of the B-787-10 (KLM 100 years)?
I noticed that the bulkheads of the fuselage are not exactly round, while I believe the 787 is. Further, the bulkheads at the tail end are not round and have an orientation for up and down. It would help if you could provide a mark on the bulkhead to indicate the closing seam of the fuselage segment, so that you can install the bulkhead in the correct position. The same applies for the formers of the fairing under the fuselage ( S, V, H and R). They need to be installed correctly, to ensure a flat bottom.


The 787 has a very characteristic elastical wing, so that in flight the wing is really crescent shaped. I am trying to capture that in this model in flight configuration. It's really fun to build this model.

[3Turner]

A model by a new (to Ecardmodels) designer has been posted. The kit, an Aero 145, is released by Hangar CZAF.


https://www.ecardmodels.com/product/...j-paper-model/

[3Turner]

A couple models posted on Ecards repainted by Rata



Ryan ST-M Honduras
https://www.ecardmodels.com/product/...s-paper-model/

Brewster Buffalo RNZAF
https://www.ecardmodels.com/product/...n-paper-model/

Three from Brent's Repaints


Lancaster
https://www.ecardmodels.com/product/...r-paper-model/

Re-2005
https://www.ecardmodels.com/product/...2-paper-model/

TA-154
https://www.ecardmodels.com/product/...e-paper-model/