Showing Visitor Messages 1 to 1 of 1
-
Hello Gil,
My name is serge stone and I was referred to you by Leif Ohlsson as you are very knowledgeable in the field of paperlamination. You may have seen my thread at the Welcome desk on building an L-19. The cowling of which, I thought rather dissapointing.In an old aeromodeler book I saw a chapter on laminating in paper by way of a hollow/female mold, so I modelled the engine cowling in plasticine. See photo's. I plan to use either newsprint or thin paper strips, well soaked in starch or another water based glue, and layer this inside the mold. The mold, I cast in dental tech. plaster, which is very hard. Could you give me any advice on a good seperating agent ? In the same article from A.M. was a way to make wheels, which looked very good.
As I can't attach the pictures here I will try to put them in the experiments section.
best regards,
Serge
