|
#1
|
|||
|
|||
Yamaha 450 Dirt Bike
This model will show all the errors I've experience
What I did - What should I've been done - Any suggestions will be welcome There is still a lot to learn |
Google Adsense |
#2
|
|||
|
|||
Yamaha 450
Problem 1 - The steering column is already glued - mistake !
It must still go into the frame. We will get to it when the frame is done and the assembling starts |
#3
|
|||
|
|||
Yamaha 450
Mistake no 2 - I cut out the white part on the ferrying that will cover the radiator. Not suppose to be cut out - So I will have to fixed that
|
#4
|
|||
|
|||
Yamaha 450
Mistake on the radiator - all the vanes show in the same direction !!
|
#5
|
||||
|
||||
Hi Henry - nice to see that you have posted this!
It looking good and nice to see that you are modelling in colour now. Don't worry about the mistakes - its only paper and you have picked them up! I have just sent you a PM re the carburettor question you had. see if this makes sense - if not PM me again and I will call you maybe.
__________________
The SD40 is 55 now! |
Google Adsense |
#6
|
|||
|
|||
Yamaha 450
Thanks Kevin.
The part of the ferrying that I cut out, I reprint it - fold it in B/W and just glued the color part over it |
#7
|
|||
|
|||
Yamaha 450
Carburetor
Frame Engine Rear arm |
#8
|
|||
|
|||
Yamaha 450
Engine and frame assembling
The rear arm is assembled too low - I've realized that when I wanted to fit the rear wheel The rear wheel was too close to the rear fender. |
#9
|
|||
|
|||
Carburetor attached to the engine
About this photo This part on the side of carburetor was cut off because I could not get the rear suspension in - I re-glued the parts when the rear suspension was fitted Last edited by hrogers; 02-13-2019 at 04:56 PM. |
#10
|
||||
|
||||
Nearly done - once you have the edging sorted out it will look very good.
And great practice for the next one!
__________________
The SD40 is 55 now! |
Google Adsense |
|
|