3D Printing

[rickstef]

we think it is a quick of the software that the forum is written on, maybe the attachment manager has trouble interpreting the picture's dimensions, and flips it sideways.

I will check with Jason to see if this is something that has occurred with other forums, or if the authors know about it

Rick

[wagnmkr]

Originally Posted by BARX2

The main problem I have is that sometimes parts stick so tight to the bed I have to whack them off with a paint scraper. So far, no damage to the bed. It has some special surface, not glass. I don't use tape, because it always comes unstuck.

I print on a glass bed and if I try to remove the print when it is still warm, or hot, it is very difficult to get off. If I wait a few minutes for it to cool, the print just pops off by itself. Letting it cool might work for you as well.

Tom