#181
|
|||
|
|||
I installed several previously built up parts including the EVA handrail, S-band in-flight antenna, rendezvous radar antenna, navigation lights, and RCS thrusters on the forward section. The only additional details to add to the forward section are some rivet details using a chrome pen but will do that later in the build. I may also skin the rendezvous radar antenna mount with black construction paper because right now it is just printed black. Not sure if it will make it look too bulky so holding off on that decision for now.
Next on to detailing the mid and aft sections. |
#182
|
|||
|
|||
Tunnel hatch detailing.
|
#183
|
|||
|
|||
Finished detailing hatch and skinning the tunnel.
|
#184
|
|||
|
|||
The bump-out over the aft section just behind the hatch was not included in the kit design, so I scratch built it. There were also gaps in the skins between the aft section and middle section which I tried to minimize.
|
#185
|
|||
|
|||
Scratch built the umbilical and underside detailing.
|
Google Adsense |
#186
|
|||
|
|||
Some mid-section details.
|
#187
|
|||
|
|||
Parts 329a/b/c/d are the docking target. Pretty straight forward parts to assemble.
Parts 332a/b are the steam vent but I scratch built because the kit parts looked too big to me. Since those are rather fragile assemblies, they will be mounted on Ascent Module later. Part count to date: 743 |
#188
|
|||
|
|||
Hi! I was just wondering if you could post the dimensions of your 1/24 LM-7? Considering upscaling Uhu02’s aswell. Just need to know rough dimensions.
Thanks! |
#189
|
|||
|
|||
Yet more wonderful work on this great model Wichita. Really enjoying all the photos.
Regards Kevin
__________________
Normally the most advanced tech I use is a pencil. |
#190
|
|||
|
|||
Ste4lth: Here are some pictures with a ruler. The cutting mat is marked with 1” squares. Hope it helps.
|
Google Adsense |
|
|