Space X Grasshopper 1/50 - Page 2

**SCEtoAUX** · #11 11-29-2014, 04:21 PM

You have made some nice progress considering what you had to start with. Looks like it will be a sturdy construction.

**merzo** · #12 11-30-2014, 02:46 PM

Nice, good, however.

Yes, I try to stability, but it is the holder must keep the building dimensions.

Today I tried to lower swingarm experimental construction.

That's what I want to try

Since four of a kind pieces to be prepared and should be building templates!

I will continue tomorrow .... Merzo

**Paper Kosmonaut** · #13 11-30-2014, 05:05 PM

Wow that's very impressive, as usual, Zoli. I really do admire your skills in measurement taking and 3D thinking.

**merzo** · #14 12-01-2014, 06:26 AM

Thank you very much

Now, I attempted to small parts of an A4 sheet and try to group the laser cutting.
Excite the result !!!

Merzo

**Konstantine00** · #15 12-01-2014, 03:59 PM

You're very good at using google Sketchup! Do you use pro or the free version? Good job on the build-it looks great.

**merzo** · #16 12-03-2014, 03:48 PM

Good afternoon

Konstantine00.
The pro version I use you, but I think it also complies with the free version. It facilitates the modeling that you can try out all right even before the paper is cut. And if you are ready to prepare Pepakura the correct size printing. It saves a lot of unnecessary work.!

Let's look at the progress of the building today.

This is what I made.

Each element 280 gr paper glued together and cut twice, shaft 80 gr paper rolled up and glued together.

The gas spring rolls wrapped Ø2mm shaft 80 gr paper.

Today, the end of work ....

Laser cutting is now canceled, because everything I cut with a knife because I was impatient ....

Merzo