#21
|
||||
|
||||
Yes, building a torus is by far the hardest part. It involves a lot of dead reckoning and building in a very predictable and consistent manner.... which is hard over a dozen feet worth of glue tabs.
|
#22
|
||||
|
||||
Also, I have also concluded that I am going to release the plans for free. There will be a link in the instructions if someone wants to put a few dollars in a tip jar.
|
#23
|
||||
|
||||
That is very generous of you, I would like to contribute once I am able again
__________________
"Rock is Dead, Long Live Paper and Scissors" International Paper Model Convention Blog http://paperdakar.blogspot.com/ "The weak point of the modern car is the squidgy organic bit behind the wheel." Jeremy Clarkson, Top Gear's Race to Oslo |
#25
|
||||
|
||||
Thank you very much for your generosity!!!
So far, you are off to a great start on this project. Everything that you have looks really good! I am following this thread closely.
__________________
If it can be thought of, it can be done. |
Google Adsense |
#26
|
||||
|
||||
My next nervous moment is when I put the struts on the collars and fit those inside the warp tori. I really hope I did all that math and spacing appropriately.
|
#29
|
||||
|
||||
Are the hex cut-outs to make it easier to firmly set the glue tabs or structural?
Very nice warp ring there.
__________________
A fine is a tax when you do wrong. A tax is a fine when you do well. |
#30
|
||||
|
||||
Very nice job so far!
|
Google Adsense |
Thread Tools | |
Display Modes | |
|
|