E - Locomotive EP 05 - 1:45 - ADW

[romanmodels]

looking good

[Styrian Spitfire]

Hello !

Now something else again - the two bogies ... I start with the center edition parts 59 ...
for the two bogies of the electric locomotive. Eight frame parts are reinforced with 0.9 mm Finn cardboard and two of them are glued together. Dry well and squeeze.

Best regards
Kurt

[Styrian Spitfire]

Hello railroad friends

By means of angle iron, the bogie is ... aligned and glued, the edges colored and slightly aged.
Several small parts now grow on the bogie, whereby I color the edges here only after the cultivation. The bearings and beams ...
... are now installed with the engines. Now let the bogies dry well.

Best regards
Kurt

[Styrian Spitfire]

Hello !

after a short break we continue here ...

The next module ... with 64 components.

After the construction of a prototype, it goes into series production. Now mount it on the bogie with the lids not yet glued on.

In the openings later the axes must be installed.

Best regards
Kurt

[Styrian Spitfire]

now the Pictures

[beckychestney]

Looking good!

[Styrian Spitfire]

Hello everybody ,

The prepared attachments ... now mounted on the bogie.

The next assembly reinforced ... and assembled, whereby the two side plates are not yet glued ...

... these are subsequently connected to the bodywork. First fitting of the bogie.

Best regards
Kurt

[Kevin WS]

The bogies have really turned out nicely G- well worth the effort.

[Styrian Spitfire]

Hi Kevin ,

thank you

Now continue with the brake system ... where again some parts are to be obstructed.

Build the brake cylinders together. Now complete the brake system ...

... where some improvisation was needed.

Best regards
Kurt

[Styrian Spitfire]

Hello

This is followed by eight spring packages for the axles. A 2 mm wooden stick is wrapped with 0.3 mm wire, and installed as a bar spring.

A 1.5 mm long toothpick tip is glued to the underside of the leaf spring.

Best regards
Kurt