White Hall Vessel ironclad 1/250 Ecardmodel
3 Attachment(s)
Hello everyone!
I started a new project. Thanks to the drawings CT Ertz colleague! Read about the boat: http://www.papermodelers.com/forum/c...-ironclad.html The Model: Scale: 1 / 250 Designer: CT Ertz The graphics are very nice and realistic. The frame and fits nicely in the deck. |
1 Attachment(s)
The pages are too long. (Picture)
Or am I doing something wrong? |
Awesome start. I have been told that the skirting is slightly over-sized on this model, and I have fixed that issue (I think). Let me know if you have an issue with that. Thanks,
CT. |
Woops. Beat my post. I ill shorten those up a bit more. i must have put in too many midship panels when flattening the parts. Just cut out the middle section as required or trim as needed, and I will do the same on the draft. Sorry!
CT |
No problem, repair (scissors ... :-)
|
|
Hello Joe, I hope you didn't run into to many issues with this one!
cT |
1 Attachment(s)
The model is looking great, I built her a little while back, other than the skirting on the hull sides all other parts are perfectly designed. Better to have too much and trim back than not enough hull side. see attached.
|
Hello everyone!
Marco- soon I will build on (no freetime :-( ) CT- does not have a problem, but there is no free time. Paper Warrior-congratulations, very nice boat! Sincerely, Joe |
No problem Joe, we all sure understand about having no free time! WE all look forward to you continued build.
CT |
All times are GMT -6. The time now is 07:45 AM. |
Powered by vBulletin®
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Parts of this site powered by vBulletin Mods & Addons from DragonByte Technologies Ltd. (Details)
Copyright © 2007-2023, PaperModelers.com