#1
|
||||
|
||||
USS Vindicator
This is thread for the beta-test build of the USS Vindicator design by Corey.
This was a long time I would build one of their boats, but lack of time... Now it is time ! The first step... the simpliest... Printing !! (with my new printer, the Epson 1400. Not bad ...) |
Google Adsense |
#3
|
||||
|
||||
#4
|
||||
|
||||
So far so good!
Folks, there is no instructions on this kit yet and only an unnumbered diagram! I will forward the instructions as I finish them but for now this wonderful brave builder is flying blind! I did get some great diagrams done of the rigging though! Good luck! CT
__________________
My models are available here http://ecardmodels.com/index.php?manufacturers_id=62 |
#5
|
||||
|
||||
Good beginning, Pat!
Don |
Google Adsense |
#6
|
||||
|
||||
I look forward to the sequel!
Regards, Joe |
#9
|
||||
|
||||
Awesome!
I am not sure if you used the inner casemate formers (on page three I think) or not but either way it came out great! Great job on the hull sides as well! Thank you! CT
__________________
My models are available here http://ecardmodels.com/index.php?manufacturers_id=62 |
|
|