#1
|
|||
|
|||
HMS Ark Royal Question
Howdy Folks,
Part #17 has me mystified as to how it attaches. BP |
Google Adsense |
#2
|
||||
|
||||
However it attaches, you have done a fine job on the model.
Don |
#3
|
|||
|
|||
Thanks Don,
This is a simple 2 letter size parts pages print out. BASE: Printed Water surface (2nd part page) glued to thick cardboard. Measures 10” by 3 1/2 inches and is 1/4 inch thick. Base Sides: A Manila folder provided strips to finish the Base sides and ends. Paper join strips added to model parts Swordfish: Tiny cutouts assembly sequence left to right. Model measures 8 1/2 inches long 1 1/2 inch wide and two inches to the top of the trash can barrel thingy on mast top. BP |
#4
|
|||
|
|||
Ark Royal
Bob
Googling a few images of the Ark Royal shows a mobile crane on deck parked astern of the funnel on the stbd side. Also some show a similar crane jib on the port side abaft of midships between 2 boats but that looks less likely for your part 17 as the boats don't show very clearly. All the best Doug |
#5
|
|||
|
|||
Another look at the diagram looks like part 17 should be on the port side below deck level
Doug |
Google Adsense |
#6
|
|||
|
|||
#7
|
||||
|
||||
Here are a couple more references showing the cranes.
__________________
The SD40 is 55 now! |
|
|