#31
|
||||
|
||||
and on to the next exciting task - the drop sides ... Window facings and anchor hoses are only installed after the drop sides have been attached Connect the two side wall parts and preform them well, then start fixing the bridge ... and pull forward ... Sincerely Kurt |
#32
|
||||
|
||||
... first glue the top at the back ... so that the bottom is still open ... and at the end close it backwards ... to over the transom Sincerely Kurt |
#33
|
||||
|
||||
Excellent work on the hull sides and stern. Your directions are appreciated.
__________________
Greg |
#34
|
||||
|
||||
Thank you Greg
Construction phase 19, the MES loops ... which will be tripled ... ... I achieve this by reinforcing with 300g watercolor paper, which is soft and therefore easy to use hands-free can be cut. Then the edges have to be colored in three shades of blue ... when I glue the bar, I divide it into four parts ... ... so I can easily adapt it ... the tiny MES distribution box is placed under the bar Sincerely Kurt |
#35
|
||||
|
||||
Very impresive, thank you for sharing!
|
Google Adsense |
#36
|
||||
|
||||
Construction phase 19a: Rubbing strip and screw protection ... a U-profile is to be assembled from three 1mm strips ... which is placed under the MES bar ... Now my approach to screw protection: the fine grid frame is rounded to fit and glued directly on the model sheet, so I can keep the shape very well and of course dry it well Sincerely Kurt |
#37
|
||||
|
||||
After it is completely dry, cut out the model construction sheet and glue the outer strip ... then the lower frame part ...
... and finally the inner bar ... starboard fits ... ... but portside the color is not right at all ... which is being repaired Sincerely Kurt |
#38
|
||||
|
||||
With the rudder fins ... the correction bow is used again ... ... the rudder fins are divided into two parts, depending on whether the ship is shown with or without the underwater ship With best regards Kurt |
#39
|
||||
|
||||
Now the views on the upper hull ... and with the lower hull The lower parts of the rudder fins are of course removable Part 48, the bow frame ... of course glued to the bow With kind regards Kurt |
#40
|
||||
|
||||
Construction phase 21, followed by various deck structures ... Parts 49/50, bridge house with observation deck and stairwell ... ... mounted on the aft deck Parts 51, engine house with skylights ... glued to the main deck Sincerely Kurt |
Google Adsense |
|
|