#41
|
||||
|
||||
Part 52, the radio house ... put on the main deck Parts 53, fore deck gun platform for 8.8 cm cannon ... pay close attention to the positioning of the small supports ... ... and glue from below ... then place on the back deck With best regards Kurt |
#42
|
||||
|
||||
sorry , the last picture ... |
#43
|
||||
|
||||
This is followed by two fans and the chimney ... the fans are ready ... ... and placed ... the chimney is glued to the machine house Sincerely Kurt |
#44
|
||||
|
||||
Most excellent work. I see you have 3D ladders. You made them? And I like the sailor standing in the hatchway. Again, something you added?
__________________
Greg |
#45
|
||||
|
||||
Hi Greg ,
Both the ladders and the sailors are included in the model kit, it really is an excellent kit. Thank you and greetings from Styria Continue with three fans and two air vent housings ... with further micro parts ... ... which are set up on the machine house With best regards Kurt |
Google Adsense |
#46
|
||||
|
||||
Hello Kurt,
I was very behind in following your work .... I just looked at the last 3 pages and it is a huge job! I look forward to continuing! Regards,Joe
__________________
My the harbour: http://www.papermodelers.com/forum/d...our-1800s.html |
#47
|
||||
|
||||
Hello Joe,
thank you This is followed by the pedestal with the large searchlight ... although large is probably wrong here The platform is placed on the lattice framework ... ... then the headlights and the railing ... now put the whole thing on the radio house With best regards Kurt |
#48
|
||||
|
||||
Parts 64/65, railing and armor plates for the observation deck ... prepared ... ... and attached to the observation deck with some minor difficulties Sincerely Kurt |
#49
|
||||
|
||||
The anchor winch follows ... which is quite delicate ...
... the construction sketch is many times larger than the workpiece itself ... anchor haws, chain stoppers and anchor chains placed, now I need a major motor change Sincerely Kurt |
#50
|
||||
|
||||
Hello Kurt!
These are very small parts, a real challenge. Do you make the barriers or do you get them from somewhere? sorry bad english, google translate... Regards, Joe
__________________
My the harbour: http://www.papermodelers.com/forum/d...our-1800s.html |
Google Adsense |
|
|