#11
|
||||
|
||||
The aft secondary gun is provided in the kit and its location is obvious, but there are no markings as where to cut. I will do it in the same fashion as the forward secondary. That omission could mean that if you weren't keeping close track of your build you could inadvertently omit these.
|
#12
|
||||
|
||||
I want to mimic the hull plating as shown in the attached drawing. So I over-plated with bristol board below the waterline. You can also see that I have since added the kit plating above the waterline, but now feel compelled to do a similar treatment on this as I did below the waterline... and that's where it stands now.
|
#13
|
|||
|
|||
for the problems youve had i have to say well done hull is looking good i like the idea you had with the guns works well please keep the photos coming great build
|
#14
|
||||
|
||||
I am sitting and watching this beauty to be build. Great work so far
__________________
Passion is the key.... |
#15
|
|||
|
|||
Nice decision to over plate the lower hull. Needed to be painted anyway.
|
Google Adsense |
#16
|
||||
|
||||
Smooth work on that hull!
Don |
#17
|
|||
|
|||
You are practically scratch building here. Nice work.
__________________
Fred Bultman |
#18
|
||||
|
||||
Thanx everyone. I am having fun with it.
|
#19
|
||||
|
||||
Aft secondary guns are in place.
|
#20
|
||||
|
||||
I went to place on the forward deck and it needs some wrap-around on its aft face to close out the gap. This piece is too short to do the job. I decided to cut it at its center and then deal with a filler afterwards.
|
Google Adsense |
|
|