|
|
|
#11
04-12-2022, 12:26 PM
|
||||
|
||||
 Fourteen transverse ribs ... glued and allowed to dry well again ... ... the side frames No. 16 follow ... everything fits very precisely Sincerely Kurt 
|
|
#12
04-18-2022, 12:29 AM
|
||||
|
||||
|
Piece 17...fit the four pockets... ... and glue it onto the frame ... and the first fitting of the underwater " torpedoes " fits ! Sincerely Kurt
|
|
#13
04-24-2022, 12:53 AM
|
||||
|
||||
|
Four tabs 17, a b c d e... Glued on the inside... ... and 17 f g h i ... placed outside Sincerely Kurt
|
|
#14
04-29-2022, 11:04 PM
|
||||
|
||||
|
Part 18, the underside of the fuselage ... I start with the fixation at the bow ... ... then pull backwards at the bottom ... and glue upwards at the rear with a 0.4 mm overhang ... ... now close the sides ... and finally glue the rear With kind regards Kurt
|
|
#15
05-05-2022, 11:37 AM
|
||||
|
||||
|
The first board wall ... glue inside with small tabs ... ... the result ... I start on the outside with gluing the side wall ... ... and pull this inside from the front to the back, the second side wall is already ready Sincerely Kurt
|
| Login to remove ads |
|
#16
06-21-2022, 11:19 AM
|
||||
|
||||
|
Hi
The anchor device , first glue the inside ... fold up ... ... and apply to the bow ... a very filigree part! Sincerely Kurt
|
|
#17
06-28-2022, 03:51 PM
|
|||
|
|||
|
Great going, and good pics of the build too. I heard the HMV kits fit together very well, but I'm quite sure you make it look easy too!
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
