CVN 65 USS Enterprise 1/300 - Page 22

**doctormax** · #**211** 09-16-2010, 05:16 PM

I am putting the mouse trap now on the build table it is his haunt of preference it seems that and maybe do a 1:1 scale model of the cat from canon see if that works do the cat lovers be mad if the mouse starts eating a cat.

**gtb -red** · #**212** 09-20-2010, 01:33 PM

**Barry** · #**213** 09-20-2010, 03:20 PM

Thanks gtb some good shots there mate

Cheated again and used thin meat skewers for the shafts at least they are level and line up with each other. Hopefully the paint will shrink overnight again and tighten up the paper usually works. With my ability to knock bits off and the size of Enterprise the rudders and props go on last. I am always glad when this section is completed. The keel plate section at the intersection of the shafts would be far better double plated it is a bit thin using 140gsm.

**lancer525** · #**214** 09-20-2010, 04:13 PM

Barry, I think it looks awesome. And I am going to steal your meat-skewer idea...

**Barry** · #**215** 09-20-2010, 06:48 PM

Thanks lancer

Now I can fit the fuel reels without worrying if they pop over the flight deck they would probably look better with some fuel lines and valves but the scale is a bit small for me