#1
|
||||
|
||||
Canon Cat
Here is my build of the Canon cat offered recently on the site. There are 2 pages of parts. I printed it at 130% on 11x17 stock which makes it 7in/18cm tall.
cat 1 head cat 2 head cat 3 head cat 3 head explain Note the blue circled area. It is not in the intructions but you need to make sure those two small tabs are inside when attaching part 2 to part 1. cat 4 body cat 5 body and head cat 5 body and head attached cat 6 front leg 1 cat 6 front leg 1 side cat 7 front legs side cat 7 front legs front cat 8 lower body It is easy to glue the lower body to the upper body because there is a large opening provided where you can reach inside and apply pressure to the 2 glue tabs used to secure the parts together. The two back legs are straight forward so no photos were taken. (Yeah, that's the ticket.) cat 9 complete no bandana cat 9 complete with bandana cat 9 complete with bandana back cat 9 complete various angles The build is easy if you follow the red arrows shown in the instructions.
__________________
~Doug~ AC010505 EAMUS CATULI! Audere est Facere THFC 19**-20** R.I.P. it up, Tear it up, Have a Ball |
Google Adsense |
|
|