The front cowl ring seems to be a little too large
(in my opinion...unless I have done something wrong?)
...anyway, a quick snip...take a milimetre or so off, and glue it back together
and now it fits the cowl.
Tail wings are on...sorry not shown here...but pretty straightforward.
Next was the wheels assembly.
At this scale, a little tricky for me!
The microscopic dabs of glue are bigger than the size of the supports!! lol
Now, the wing supports are a whole other ....problem!
(I'll be nice)
I'm not sure how I'm supposed to get all these supports in place, securely, and then line them all up with the second wing?!!
haha...this is an adventure, I will admit that!!
I have resorted to making small incisions in the wing surface,
dropping a dab of glue into the opening and fitting the strut into the the incision.
I figure this will make a stronger connection for when I have to play around attaching it to the second wing.
(I also still have to seal up the wing ends of this wing)
All the long struts are in, now to tackle the four smaller ones!