View Single Post
 
Old 10-24-2010, 09:32 AM
cgutzmer's Avatar
cgutzmer cgutzmer is offline
Design Admin
 
Join Date: Jun 2007
Location: Sun Prairie WI
Posts: 7,285
Total Downloaded: 0
Thanks Dave - I will look around and see what I can do in inkscape...

OK! Got some curves put on the cowl - this will be harder to look right than I first thought... SURPRISE! I printed this one at 150% after making the curves.

It helped show me a couple spots where my lines are a bit off. I can also see the curves look pretty crappy. While it looked good on the compute they did not translate well to the built cowl. I need to start the curve MUCH sooner to get it to flow properly as on the actual plane.... Wish me luck, I am not sure I am up to the task at the moment...





Reply With Quote