It is the Fiddlers Green P-26 reduce approximately half size. So it is just a little more than three inches across now.
But my workmanship is poor... I do all of this just today in about an hour or ninety minutes time. So the glue was still wet while I try to cut the slots for the wing, etc. I do not have much time until the end here and I have some matters tomorrow to attend.
So I make an effort although I apologize for the poor workmanship again.
The front part with the board of instrumentation. I did make a black paper disc to help keep the shape round.
The next segment forms perfectly around my glue tube cap
And the work so far:
I think this may not be the most good model to start with. The designer for some dumb reason switched from the main seam to be on the bottom for the front of the plane, to the top on the back. It is more difficult here to join as the body it will go from round behind the pilot area to flat for the tail right along the glue line.