No thread I know of. However, when confronted with this problem, I 'rough cut' the part leaving as much paper as I can beyond the part outlines. I score the fold lines, then fold the paper holding a metal ruler with its edge along the fold line. This is the same principle as using a metal break to fold sheet metal. After the folds are made, I then trim off the excess paper around the outline of the part. And, if all else fails, do as I do and cheat...enlarge the little SOB to 1:24 scale.
__________________
It's not good to have too much order. Without some chaos, there is no room for new things to grow.
|