Thread: Apollo command module - 1:12
View Single Post
 
Old 01-16-2012, 11:41 AM
kenlwest kenlwest is offline
Member
  
Join Date: Jun 2008
Location: Lake Orion, MI
Posts: 1,426
Total Downloaded: 0
Progress Report:

I redesigned the side bays. The white patches on the bottom (closest to the heat shield) is where the electrical trays will be. The upper half of the trays will be attached to this assembly, and the lower half of the trays will be attached to the lower compartment. It was the only way I could think of to allow the 2 halves to dis-assemble to show the interior while minimizing the gaps while assembled.

I took a few pictures to show how the interior looks so far when looking through the exterior openings.

Ken
Attached Thumbnails
Apollo command module - 1:12-cm42-001.jpg   Apollo command module - 1:12-cm42-002.jpg   Apollo command module - 1:12-cm42-003.jpg   Apollo command module - 1:12-cm42-004.jpg   Apollo command module - 1:12-cm42-005.jpg  

Apollo command module - 1:12-cm42-006.jpg   Apollo command module - 1:12-cm42-007.jpg   Apollo command module - 1:12-cm42-008.jpg  
__________________
Comments, questions, advice and critical feedback are welcome!
Reply With Quote