|
Well the problem is I am not that great modeler yet. I am not very good at adding detail. Further more you have to realize that Max was not intended for use as a hard surface design tool unlike Rhino especially with Tsplines doesn't handle surfaces well or very easily for someone who knows very little. I would love to have all that detail on my model, but I am just not there yet so doing by hand is the easiest way to get it. I have a set of scale blue prints. They are what I used to build my model. I sell them if you would like a copy. I sell them for 20 each. They are the same scale as my boat. 22 inches long for the 707. The UX prints are 40 because they are HUGE! and cost a lot to get printed. I accept paypal fyi. PS you really should get in to TSplines it will cut your modeling time in half.
|