The hull frame is made of two halves which glue in the middle to form a keel and then fold out to form the base. Double sided parts form the ribs. Sockets for the masts are built into the hull frame. So far the fit is very good. Formers No.6 were fractionally short on each side. It probably is my fault and if needed can be padded out a little. The yellow colour on the formers is because I printed on the back of some sheets of a model I decided I was not going to make.
Last edited by Robert Woolley; 04-11-2013 at 11:05 PM.
Reason: extra information
|