Time for the build!
All parts fit in one A4 sheet.
Engine Assembly:
I encountered serious trouble fitting the cowling. I didn't give enough allowance/space between the cylinders and the cowling. I had to peel off the tops of the cylinders to make it fit.
I'll adjust the model in META later.
Fuselage:
Nothing special...pretty straightforward.
Rudder Assembly:
The vertical stabilizer wraps around the tail end of the fuselage.
Elevator Assembly:
Again, nothing special... moving on..
Wing Assembly:
I had a bit of trouble with the wing spars. I had to clip off a bit of the wing spars to make them fit. I'll need to adjust this in Metaseq.
Landing Gears
Wheel spat parts
Rear wheel parts
I was expecting trouble from the wheel spats. But surprisingly, they went together smoothly.
Almost there...
Propeller and doodads
For the propeller shaft, I used a bamboo toothpick.
Rigging
For the rigging, I used cotton thread stiffened with CA:
Done!