Thanks! I think this will work up better than the original images from the Papermau. I am taking time to reinforce the inside of the walls and will be detailing it some too. Also, the lean-to section on the end isn't big enough to get a vehicle into, so I will make it twice as long by printing two copies of it and joining them.
I want to extend that little awning roof on the front of the building out and make it into a covered area with the gas pumps just under the edge, leaving space to drive a vehicle under the awning.
I also found a hydraulic lift like was seen at a lot of stations. It is in another gas station kit so I will print those parts. I might put it up in the air with a vehicle on it. I don't have any vehicles in hand yet though.
__________________
---
Ken
The advantage of simplifying origami are twofold.
|