HI All
here is a few photos of the build as it currently stands, my progress has been a bit slow as I have had to rebuild my Laptop due to system just going slow.
What I have found so far is that bends and very tight rolls colours lasers are not friends as the ink lifts off from the paper, but with the main boiler been a large roll this did not happen.
One thing is noticeable between the two prints is that the ink printer been a Canon and set to high detail and comparing it the colour laser is the print quality is way better on the laser but you loss on the bending and rolling aspect of the build. in both cases the same batch of paper was used for printing the art works.
More photos will follow.
R