|
BOSS HOSS has been updated again! LOL
Sorry, but its obvious that a direction on the model sheet is misleading
and if the builder doesn't pay attention to "mountain" and "valley" folding,
they will make a bigger error.
The rear Deck Lid (Trunk/Boot area) is to be scored and bent ONLY at the lower end of the fastback.
You do not crease and bend right out to the edges of the Body (across the Fenders).
AND the fold is a "valley" fold (indicated by a dotted line instead of a dashed line).
I did not want to put the dotted line across the body, but it looks like I will have to
...so that it is clear to the builder where to crease and fold.
I've made the dotted line thin, and white, so it should almost disappear during printing.
It will probably be visible on high res printing like Laser or Photo Paper Printing.
Once again, you'll need to go and redownload the model to get the updated version.
|