Quote:
Originally Posted by Algebraist
... It is a bit of a nightmare thing to make (or so I have found!).
|
Yes it is, and in addition, reducing at half, the cutting tolerance decreases and every micro bump on the edge doesn’t allow a good adhesion between the adjacent rings.
Quote:
Originally Posted by spacerunner
... how did you fasten the rings during gluing?
|
I didn’t fasten the rings, but, starting from an end I glued small portions of the edge a little bit at a time, keeping it tight. At the end of the process I had to trim for a right fit. When the glue was dry enough, I used a small iron ball to smooth the joint.
Quote:
Originally Posted by Richschindler
Amazing build so far kind of sums it up. Can't wait to see it finished.
|
... me too
Thanks for the encouragements.
Best, Nando