Here is my build of the Canon cat offered recently on the site. There are 2 pages of parts. I printed it at 130% on 11x17 stock which makes it 7in/18cm tall.
cat 1 head
cat 2 head
cat 3 head
cat 3 head explain
Note the blue circled area. It is not in the intructions but you need to make sure those two small tabs are inside when attaching part 2 to part 1.
cat 4 body
cat 5 body and head
cat 5 body and head attached
cat 6 front leg 1
cat 6 front leg 1 side
cat 7 front legs side
cat 7 front legs front
cat 8 lower body
It is easy to glue the lower body to the upper body because there is a large opening provided where you can reach inside and apply pressure to the 2 glue tabs used to secure the parts together. The two back legs are straight forward so no photos were taken.
(Yeah, that's the ticket.)
cat 9 complete no bandana
cat 9 complete with bandana
cat 9 complete with bandana back
cat 9 complete various angles
The build is easy if you follow the red arrows shown in the instructions.