Thanks Sergio!
I wanted to re-use some of the details I had made previously for my Land Raider, but unfortunately most of these are too big, especially the aquilla.
So I set out to make a smaller one using green stuff:
I then made a garage mold, which I cast using apoxie sculpt.
To speed up the process I did not let the apoxie sculpt cure in the mold; I used glue-covered card to pull the casts out of the mold, and once they all cured I dunked them in water. This loosened the glue so I could pop the casts off, then clean them up
Here is a shot of the front of the Raptor
