Hi Rporter,
thank you for purchasing 3d hull from my Shapeways store. I think you bought upgrade sets too. Thanks.
If this is your first time with this type of material I would suggest to:
1. Expose it to UV light for few hours under uv lamp or sun
2. Wash with dishwashing detergent diluted in water using soft toothbrush and than rinse under running cold water
3. Let it dry, no hair dryers of any kind, and finally proceed with some sanding and polishing where required.
You are absolutely right about the deck surfaces. Personally I'd prefer using modeling putty and than sanding it flat rather than dry sanding printed surfaces. It might be slightly easier this way.
Anyways, good luck with your project. It's a hobby as long as you get a kick out of it...
Darius
__________________
Paper Lab
|