Hello everybody
I realized that I did not write anything for almost 2 and a half months
Partly because we moved to other house and it took some time to recover, partly because the digger was damaged during the moving.
So, new update.
Had to remake the hinge number 1 again because of previous one was damaged
The damage is seen on the picture below
And then I continued to hydraulic actuators (pistons)
Each actuator is constructed from
Front small tube
Aluminum cover for the front tube
Rear large tube
Three stopping rings that allow internal tube move inside external one
Two end connectors
Two rings that sit on the external tube
Front and rear hydro line connectors
A stop block (only on two actuators)
Hydraulics tube made from PVC covered paper clip painted with permanent marker.
To be continued.
|