View Single Post
 
Old 11-15-2019, 02:15 AM
jaffro's Avatar
jaffro jaffro is offline
Member
 
Join Date: Jul 2009
Location: Melbourne, Australia.
Posts: 1,102
Total Downloaded: 195.36 MB
Thanks Maurice. I actually already own a Brother Scan n Cut which I've used to cut out some pre-printed kits with limited success. I didn't buy the scan n cut just for models and haven't really played around with it enough to know if it's going to be good enough to cut out formers etc from thicker card like 1mm, initial tests suggest maybe not.

I've found the accuracy and tiny details achievable with my 3D printer quite impressive so I'd like to see how it goes as a laser cutter, it's simply a matter of attaching the laser head to the extruder head of the 3D printer and I can pick one up for around $100. The only other requirements are a bit of wiring and maybe some software which might be free, depending which one I decide to use.
__________________
Recently Completed: Modelik Scud

Currently Building: Angraf M1070/M1000
Reply With Quote