Hello everybody,
after the
LH2 Tank was floured, it was now the turn of the
LO2 Tank and first waited for his demasking,
which was done quickly.
Then the rear, already floured tank was taped,
and the ET impaled onto the bamboo stick for flour coating.
And then I went back to the flour cellar, only this time with reversed arrangement of the holding jig, since I am right-handed.
Afterwards the warmed spray adhesive can was shaken vigorously again and the
LO2 Tank was sprayed all around and dusted abundantly with the rice flour, which was pressed on with the fingers.
The excess loose flour was then shaken off by tapping lightly.
And so everything should dry properly before the remaining flour can be brushed off.
Until then we still have to be patient a little bit.