and for the Truss-specific additional details
1. for the S-1 Truss, I added the following:
- grapple fixtures on the Ammonia Tank Assembly (installed by the STS-131 spacewalkers after they removed and replaced the ATA with a new one)
- I simulated the ripped thermal raidator panel by first drawing the inner panel in paint, then have it printed in the same dimensions as the radiator panel before gluing it in place... then, before gluing the radiator panels together, I simulated the rip based on photos, then, using my X-Acto knife, carefully cut the appropriate panel in the same pattern as the original, the. curling it up.. I intentionally allowed a bit of wrinkles while doing so, as the actual also has it
2. for the P-1 truss, I only readjusted the handrail on the workstation where the FHRC is installed, to an area just right beside bulkhead 14
so there, despite some mistakes done during the build, I must say I’m very pleased with the results, which is very encouraging especially for the next build, which will be the P-3/4 and S-3/4 trusses, which I am now building as we speak
thanks much guys for looking, stay tuned